The remediation crew left yesterday. The plastic is gone, the air scrubber is gone, and the hall and the pantry are bare studs to about four feet up, with a strip of clean slab where the carpet pad used to be. The plumber rerouted the cracked line through the attic last week. Now you need the house to look like a house again. This site connects you by phone with an independent local provider who does mold damage repair in Plano and across Collin County.
Rebuild starts with the same meter that ended the removal. The crew reads the studs, the bottom plate, and the slab where the pad was, and nothing closes until those numbers sit where dry wood and dry concrete should. If the remediation company left a written release or a Certificate of Mold Damage Remediation, which Texas requires within ten days of finishing, the repair crew works from it.
Then the scope is written: drywall and insulation by the sheet, texture to match the existing ceiling or wall, baseboard and door casing by the foot, paint by the room, and flooring by the square foot with the transition strips noted. You see that list before anyone buys material.
Two decisions are yours before the crew comes back. First, the floor: if the hall had carpet over a pad, this is the moment to decide whether carpet goes back or a hard floor goes in, and if you choose a floating floor over the slab, ask about a pad with a vapor barrier. Second, paint: whole-wall repaints hide a patch better than touch-ups, so decide which walls get a full coat.
Keep the water off any fixture the plumber has not finished, and keep the slab area clear of boxes and rugs until the crew returns. Hold onto the remediation company's photos and moisture log; your adjuster will want them with the repair invoice.
Insulation goes back into exterior walls, new drywall is hung to meet the old cut line, and the seam is taped and floated. Texture is matched to the rest of the wall or ceiling, which in Plano usually means an orange-peel or knockdown finish that takes a practiced hand to blend. Baseboard, shoe mold, and door casing are replaced and caulked, then primer and two coats of paint.
Flooring comes last: carpet and pad restretched to the existing seam, or a floating floor laid over a new pad with a vapor barrier against the slab. Cabinet bases that were pulled are reset or replaced, and the toe kick is refitted. If a wet spot shows up during rebuild that the first crew missed, the repair stops and that section goes back to mold removal. Rebuild after a multi-room job follows whole-home mold remediation, and a rebuilt bathroom follows bathroom mold removal.
Rebuilding drywall alone rarely needs a permit in Plano, but anything that moved plumbing or electrical during the job does, and the permit goes through the city's Building Inspections office for houses inside the city limits, or through Allen, Frisco, McKinney, or Richardson for houses there. Repair that follows a slab leak nearly always moved plumbing, because the common Plano fix for a cracked line under a post-tension slab is to abandon it and run a new line overhead rather than cut the concrete.
That overhead reroute matters for the rebuild: the new line comes down inside a wall that the drywall crew has to open or has to leave open until the plumber is inspected. Texas separates the trades here. Mold remediation is a TDLR license, plumbing is the State Board of Plumbing Examiners, and the drywall and paint are general contracting with no state license, so ask the provider which company does which piece and who pulls the permit. The February 2021 freeze repairs taught a lot of Plano homeowners this sequence the hard way, with attic lines replaced before ceilings could close.
Have the address, which rooms are open, and whether the remediation crew left dry readings or a certificate. Say whether the plumber is finished, whether any permit is open, and whether you have chosen flooring. Call (972) 787-0657.
Standing byDescribe the leak that started it and where the growth is showing. The call goes to an independent local provider who handles mold removal and remediation across Plano, Allen, Frisco, McKinney, Richardson, and the Collin County suburbs.
Growth on drywall after a slab leak, a water heater, or a washer box let go: room sealed, wet board cut to the meter line, framing HEPA-cleaned and dried.
A dark patch handled by how far the water traveled, not its color: containment up, porous material out, hard surfaces cleaned, the leak fixed before closing.
A slab leak that ran for months or a line that split in a freeze and soaked several rooms, mapped wall by wall and cleared in zones as one project.